-
Continue reading →: How to break a chain.
I had to break a chain last night. This is an easy way that I use. Figure out the length you need and note the link you need to pop off. Grind that link in a grinder Now you can bend the link and it will come right off leaving…
-
Continue reading →: Tri Rad brakes suck
I got all new brake pads. The front brake is so nice! I need to get new pads for all my bikes. The rear brakes use a pulley system that totally sucks. So I am going to use a slitter and run cable to each side. I got this splitter…
-
Continue reading →: Bendy Fuel filter
Heat it up and let it bend! Use the screwdriver to make smooth out the inside tube so it isn’t constricted. After this bend, I put the screwdriver deeper and made that tube large inside again.
-
Continue reading →: Implement headlight
I needed a new sealed beam headlight for a hobbit. I grabbed this one from Fleet Farm for a tractor. 12v 35w. I cut the rubber surround off and it fits in a Puch bucket perfect.
-
Continue reading →: Hobbit build
I have gotten a lot done on the Hobbit. installed the new treats pipe and made pedal clearance. Made a custom twisted 10mm wrench for the carb nuts. Boner filter and dick choke lever. Made a custom LED brake light bracket and routed the wire inside the frame.
-
Continue reading →: Mini Rigid Magnum seat finished.
Finished the seat on my Mini Rigid Mag. Used high density foam and a exacto knife. Attached with contact cement.
-
Continue reading →: How to clean cases.
I found a great new way to clean cases and wanted to share it with you! I did these cases the other day.
-
Continue reading →: Picked up some Hobbits.
Picked up two PA50IIs. Starting the tear down this weekend. Found this broken mount on one of them. Jake Should be able to fix it. This one also had spark. It always amazes me when they have spark or run after sitting for so long. I got the engine cracked…
-
Continue reading →: New shelf and more garage organization
This winter I have been organizing, insulating, wiring, and other stuff to my garage. Last night I threw up a new shelf. Felt good to get some more free space.
-
Continue reading →: Rigid Magnum
Ive been working on a rigid magnum for a little while. Here is what I have so far. Will hooked up powder, and Swoops Kevin did the decals. I am also experimenting with different foams and foam cutters to make a seat pad.
Hello,
Corn Ped
Mopeds, Dirt Bikes, E-Bikes, Videos, Etc.
Cornped 