-
Continue reading →: Treats and Sport Wheels.
Got a Murray tank for the Swinger build. i am not sure if ill paint it. its in such good condition. I thought these vintage parts were fun, still in plastic inside. Got a polini ‘D’, 28mm oko, and a Dio carb in the mail. Found these cables, i like the…
-
Continue reading →: Night at the shop
Didnt get as much work done as i wanted, but its a good start. . . Working on the main gear. Shaving off that extra weight. Getting the shoes down to 60 grams each.
-
Continue reading →: Motion Left Mopeds E50 Clutch brace 1/2 review
Its winter here, and i am too excited to wait until spring to post the whole review. when its warmer ill finish this review with some test runs. This is the new clutch brace from MOTION LEFT MOPEDS. It fits both the 3 shoe clutch and the 2 shoe clutch. The plate…
-
Continue reading →: Grinding
I did some angle grinding on the kromag frame, i took off the rear reflector tabs and the suport brace. its strong enough without it, and i think it looks better. After that, i started case matching a e50 for a polini and my dremel broke half way thru. Luckily i had…
-
Continue reading →: Skating and Music
Got to skate the Hiawatha and listen to some music Friday night. I took some video in between runs.
-
Continue reading →: Rigid Kromag in the works
I got hooked up with a rigid kromag, ill grind some stuff off and powder it. my plan is to use a small Murray tank and make it a small racer. Updates to come.
-
Continue reading →: Projector Headlight
I pulled these out of a rocket, I am not sure what kind. I took apart the housing and pulled out the projectors. I had to sand and grind some parts off to make it smoother. After i took it apart i painted the housing with engine enamel and than baked it…
-
Continue reading →: VESPA Stuff
Picked up these Wheels. I think Tyler wants them. . . The front is a 17″ with a Gizelle and the rear is a 16″ with a Pirelli tires. nice.
-
Continue reading →: Pleasant E50 Surprise
I bought a e50 from a junk yard, when I pulled it apart, it was the cleanest engine I have ever seen. It even has original Puch bearings. I think I could have just ran this thing the way it was. This was the last engine I pulled apart.
Hello,
Corn Ped
Mopeds, Dirt Bikes, E-Bikes, Videos, Etc.
Cornped 