-
Maxi N
on
Continue reading →: Maxi NI have been working on this maxi n. Its a polini with a crank pipe. I used some special dye/paint for the side covers and it seems like it isnt going to chip. Time will tell.
-
Continue reading →: Made a Motobecane seat
Custom Motobecane seat for a Casseroller.
-
Continue reading →: Free Spirit seat cover
I made a free spirit seat cover for a friend. Here are some photos of the progress.
-
Continue reading →: Work on the Van
I have been doing a lot of work on the 78 shorty. Trying to make it quiet inside and nice. I am going to be able to fit so many mopeds in here.
-
Continue reading →: Made some new foot pegs and went for a rip
Made some new wider foot pegs for the JR80 by cutting some steel strips and welding them onto the original foot pegs. They are great!
-
Razor MX650
on
Continue reading →: Razor MX650I picked up a Razor MX 650. The batteries were toast. Replaced with a scooter battery and its good as new. I plan on building a new battery pack for it and configuring a new motor and controller to get more speed. I started off by stripping it down to…
-
Peugot 103
on
Continue reading →: Peugot 103Picked up a Pug 103. I have had a bunch of 103s but they have always been missing too many parts to bring back to life. First thing I did was chop the seat and lower it. Took a little welding but it worked great.Then I threw some JR80 low…
-
Continue reading →: XR200R Test Ride
There is a great little service road next to the rail road tracks by my house that I ride. I took the XR200 on it to test it out the new top end. Seems great.
-
Continue reading →: Xr200r top end refresh
After numerous problems with the Xr I finally called it quits. I took the top end to Bill Bune for a bore and valve job. I slapped it back together and it runs so much better. Lifts the front end in 2nd no problem now.
-
Continue reading →: Another xr200r seat update
I decided to redo the xr200r seat again. I took the seat cover off and shaved the foam down with an angle grinder and flap disc. I made the read smaller so it would be more flush with the rear fender. For the seat cover, I used an crf cover…
Hello,
Corn Ped
Mopeds, Dirt Bikes, E-Bikes, Videos, Etc.
Cornped 