-
Hug Update
on
Continue reading →: Hug UpdateChanged the seat, put on a Jog CDI box and got it running. ‘
-
Continue reading →: Seat work for the HUG
Working on the seat. I am using a stock hobbit seat that I have cut a about 1.5inches out of the center. I also reshaped the foam with a flap disc. I also used to stock hobbit rear seat mount but welded in a center piece to connect to the…
-
The Hug
on
Continue reading →: The HugLots of slow slow progress. I cut up a rare rigid Peugeot 103 and am putting a hobbit subframe on it. Simple Dr kit, Del 21, Camino rear pulley, EBR Hydros, Mags. Something simple and reliable.
-
Continue reading →: Hobbit rebuild
Got a change to tear apart this hobbit engine. The ignition side was perfect but sure enough the vario side seal was bad. I put in a new stuffed crank and DR Kit and sealed it back up.
-
Continue reading →: Picked up a pw80 and a husky 50
Picked up a couple bikes The pw80 needs a lot of work. But the husky just needed a clutch. It ripps!
-
Continue reading →: Vapor Blasted Cases
I got some e50 cases vapor blasted by HydraMoto Vapor Blasting. They turned out like a million bucks. You gotta get your aluminum Vapor Blasted!
-
Continue reading →: New Pipe for the Mag X
Chopped up a Simo to fit to the Mag X.
-
Continue reading →: Fun Thursday ride.
Had a fun Thursday ride. Rode the Tri Rad. Ended up blowing my headlight and had to use a bike light to get home. FUN FUN!
-
Continue reading →: Picked up a puch dart
This thing is sweet! Super slow! Super Stock. 170 miles.
-
Continue reading →: VM18 intake for a puch
I was sick of the bing on the tri rad so I went to a vm18. I used a puch exhaust header to make an intake. Matt let me use his lathe to turn down some tubing for the custom intake. I have not tuned it yet but it runs…
Hello,
Corn Ped
Mopeds, Dirt Bikes, E-Bikes, Videos, Etc.
Cornped 